Bob's Biggest Balls Ever

[fmuir]

... I had not seen these previous posts because I have not been receiving subscription notifications.

Frank, can you see what is wrong with the code you mentioned a few posts back about the order modify errors - I can't?

@ SteveHopwood,

Thanks for update v1j.

How does somebody subscribe to a thread? I remember that gahietman (?) just recently discovered how to subscribe to a thread.

I'll check into the code in question!

-Frank

[spotdespot]

How does somebody subscribe to a thread? I remember that gahietman (?) just recently discovered how to subscribe to a thread.

I'll check into the code in question!

-Frank

Bottom left Frank - see attached - where it says "Unsubscribe" for me.

[fmuir]

@ spotdespot
Thanks for the jpg. Mine currently says 'subscribe.' I was mistaken about the user that I had referenced before. It was actually Bunker on the "gms' Double Big Mac EA with bells and whistles" thread.

Regards,
-Frank

[fmuir]

...
Frank, can you see what is wrong with the code you mentioned a few posts back about the order modify errors - I can't?

@ SteveHopwood,
That particular OrderModify command worked fine! However, the reasons that the errors (error 1 - no error and error 130 - invalid stops) were generated, causing the Alerts and Prints, were because:

The new 'NewStop' value was identical to the previous value for error 1 (No Error).

The new 'NewStop' value was closer than MarketInfo(Symbol(), MODE_STOPLEVEL) to the current price for error 130 (Invalid Stops).

These errors might have occurred at different times, and with different pairs, because of the dynamic interaction of the calculations that occurred earlier in the ScalpTradeManagement function?!

Hopefully this information helps?

The OrderModify statment in question is now at line 2488 of BBBE v1j.

Regards,
-Frank

[bazze]

Is there anybody in this exellente forum who have a good set-file to share?...............Please..........

[ovisun]

Is there anybody in this exellente forum who have a good set-file to share?...............Please..........

See page 15, but only for trend trades, 24 hours trading.

Cheers.

[cuzgeorge]

still testing but not showing good progress so far. Need some time to find a good set file and lots of thinking time.
regards
cuz

[fmuir]

Hello,

I checked the ADX values displayed on the output screen, by creating a script. Running that script created output that I compared to a screenshot made at the same time. The values matched.

However, in my opinion, displaying the numbers in isolation doesn't tell if they are rising or falling. Could a colo(u)r scheme be adopted, for the output screen, that tells when the ADX is positive but falling or that the ADX is negative but rising?

-Frank

[trader689]

ovisun,

your setfile is on p16, not p15

have loaded it on dfmarkets before, but like you said, it was opening scalp trades even though scalping was set to false

have loaded it up now on a hotforex demo see if it fares better, thanks for the upload

Is there anybody in this exellente forum who have a good set-file to share?...............Please..........

See page 15, but only for trend trades, 24 hours trading.

Cheers.

[ovisun]

@trader689,

Did you use the last version from post 1, which is v1j?
Because after I installed the last version there were no more scalp trades for me.

Regards.