there will only be alerts for the actual open candle, this was in all versions so coded, for avoiding to have more time alerts...Gertje » Sun Feb 01, 2015 10:23 am wrote:I noticed on D1 trading that sometimes signals print on the previous candle, and therefore NOT generate alerts. This happens mainly just after rollover, when another complete bar is taken into the calculations.ronemshoff » Sat Jan 31, 2015 6:18 pm wrote:
that is correct. Why dont you run your own test using 16.02 as i did. You should see many symbols on a M30 chart or lower time frame. Then carefully go through the experts file and write down the alert in that file, noting the type of alert and corresponding symbol, then check your chart to see if all of those symbols are on the chart at the proper place and times. You will probably find that they are. then look at the chart and note any symbols that are on the chart and are not in the experts file. You will probably find about 15% are on the chart but are not in the experts log. That was my finding. Be sure you dont do anything of the many actions that will re-initialize your chart. If you do you will get an entirely different chart and symbol placement. that is why many are pulling their hair out. you will also find it benificial to change the various symbol colors around so when it prints over lapping symbols they show up. red small arrows for example will not show on red big arrows when they print at the same time and place. rare but they do. use a black background chart, white bars only (not candles) big yellow down, big turquois up arrows, and the rest default. makes for easy chart read. ron
Could this be what is causing your "issue"?
Cheers
Tommaso
