stevehopwoodforex.com
https://www.stevehopwoodforex.com/phpBB3/
Print view

Technical problems running HGB'nG? Post here.
https://www.stevehopwoodforex.com/phpBB3/viewtopic.php?t=4570
Page 5 of 15
Author:  SteveHopwood [ Tue Feb 02, 2016 4:24 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

cyberevil » Tue Feb 02, 2016 4:11 pm wrote:Anyone else getting the following error? been getting these and I'm starting to wonder if these are false positives that are being caused due to large number of buys and sells being sent i.e 20.
It isn't an error. It is a safety feature. I have explained it both in the user guide and earlier in this thread.

:xm:
Author:  cyberevil [ Tue Feb 02, 2016 4:53 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

Found it... thanks!
Author:  krzysiekqq2 [ Tue Feb 02, 2016 10:28 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

I am seeing this about 5 times a day. I have 2 min setup between OpenClose positions. Before I saw 10 positions opened and closed within 1 sec, and broker explained to me when I called them, it needs to be on my side as they see comments at trade and robot is doing so, and reject any claim.

Cheers, Krzysztof
Author:  patmontes [ Wed Feb 03, 2016 4:39 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

Hi Steve
I have a situation where there was a semafor high. Is it right to expect that the EA have the buy trades closed and then send a fresh grid of buys then move untriggered sell stops higher?
Using version T and no freezes encountered.

Thanks... i must be doing something wrong...
Author:  SteveHopwood [ Wed Feb 03, 2016 4:48 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

patmontes » Wed Feb 03, 2016 4:39 pm wrote:Hi Steve
I have a situation where there was a semafor high. Is it right to expect that the EA have the buy trades closed and then send a fresh grid of buys then move untriggered sell stops higher?
Using version T and no freezes encountered.

Thanks... i must be doing something wrong...
Did I ever mention in passing, briefly, as an aside in brackets perhaps, how much I loathe, detest and despise writing user guides?

I am sure I must have done, somewhere.

At the same time, I may just possibly have added that I get mildly irritated by questions that prove conclusively that the questioner cannot be arsed to read it.

Re, "mildly irritated", I enjoy and employ Masterly British Understatement.

:xm:
Author:  patmontes [ Wed Feb 03, 2016 5:22 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

Found the reason after a quick review! Cheers!
It was an instance where the semafor was earlier on a lower location and the EA already closed some trades then the grid currently is a result of fresh stops being sent already. My bad. My apologies.
Author:  Maximilian [ Thu Feb 04, 2016 3:19 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

Hey Steve,
thank you for solving this freezing issue. No more problems :yahoo: even on my undermotorized amazon VPS.
Cheers Max
Author:  smpcoe [ Mon Feb 29, 2016 7:16 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

Love HG 'n B; it's fun to watch on different time frames.

While watching on an H4 timeframe, the Semafore (5) signal started to form on a new candle but the " Low signal emerging on current candle" message did not show up. This was on the Holy Graily Bob 'n Grid 'z' version, so I checked it on the 'v' and 'x' version, but it was the same thing.

Once the candle completed, the " Low signal found on previous candle" showed up just fine; has anybody else seen this?
Stan :?:
Author:  SteveHopwood [ Mon Feb 29, 2016 7:34 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

smpcoe » Mon Feb 29, 2016 7:16 pm wrote:Love HG 'n B; it's fun to watch on different time frames.

While watching on an H4 timeframe, the Semafore (5) signal started to form on a new candle but the " Low signal emerging on current candle" message did not show up. This was on the Holy Graily Bob 'n Grid 'z' version, so I checked it on the 'v' and 'x' version, but it was the same thing.

Once the candle completed, the " Low signal found on previous candle" showed up just fine; has anybody else seen this?
Stan :?:
The bot is coded to look for a signal on the current candle only if there are market trades open - a cpu saving thingy.

This is a problem if you had market trades open, otherwise not. Let me know if I did not explain this in the user guide and I will update it. Could you have a look for me, please?

:xm:
Author:  smpcoe [ Mon Feb 29, 2016 10:48 pm ]
Post subject:  Technical problems running HGB'nG? Post here.

The bot is coded to look for a signal on the current candle only if there are market trades open - a cpu saving thingy.

This is a problem if you had market trades open, otherwise not. Let me know if I did not explain this in the user guide and I will update it. Could you have a look for me, please?

Hi Steve- The user guide didn't mention it so I'll set up a bunch of open trade charts & let you know.
Thanks, Stan
All times are UTC Page 5 of 15