forexripper wrote:Only numbers on the right should be fine for now. I was thinking of this using the currency slope strength normal indicator and also with true. Kind of optional if possible. What do you think?
As my idea is of ratio hence CSSDiff will not be required.
Is it possible to create an EA for it so we can test that too. Too demanding may be. Feel free to reject my ideas. Thanks

NeoTrader wrote:

forexripper wrote:Only numbers on the right should be fine for now. I was thinking of this using the currency slope strength normal indicator and also with true. Kind of optional if possible. What do you think?
As my idea is of ratio hence CSSDiff will not be required.
Is it possible to create an EA for it so we can test that too. Too demanding may be. Feel free to reject my ideas. Thanks

Look here http://www.stevehopwoodforex.com/phpBB3 ... f=37&t=639
I hope this is what you wanted...but only related to the currencies of the currency pair on the chart.

Please check if the ratio calculation is as you want it to be.

happy trading,

NeoTrader

forexripper wrote:From the slope numbers the ratio has been calculated correctly. Now if we can come up with an EA for this it would be great. However, the EA should only consider a trade when one currency has slope above 0.4 and the other below 0. Thanks

// Setup CSSRatio line
if ( showRatioLine ) {
	if ( MathAbs( arrCurrencyBase[i] ) < MathAbs( arrCurrencyCross[i] ) ) 
		ratioSlopeValue = MathAbs( arrCurrencyBase[i] ) / MathAbs ( arrCurrencyCross[i] );
	else if ( MathAbs( arrCurrencyBase[i] ) > MathAbs( arrCurrencyCross[i] ) ) 
		ratioSlopeValue = MathAbs( arrCurrencyCross[i]) / MathAbs( arrCurrencyBase[i] );
				
	lineCSSRatio[i] = ratioSlopeValue;
}

supramannz wrote:I was wondering if anyone had modified the slope strength indicator to include lower TF? eg. H1 or M15. I had a quick crack at modding it myself but it would seem my programming skills are non-existent.

Also how difficult would it be to add an alert system? For example when slope goes over .8 an audible alarm sounds.

Finally thanks for your effort putting together the indicator, its much appreciated.

supramannz wrote:Thanks for the quick reply.
I dragged a second one already and had a play round with time frames using the same format as H4 (i.e. 1h = H1) but it just displayed D1 (assume the default). I also input 60 or other variables but it kept displaying the D1.
What would I input and were to make it for H1?

supramannz wrote:I am talking about Slope Strength v1.0.2. I looked for documentation on the indicator in this thread but apart from the brief on pg.1 there didn't appear to be any?
in Slope Strength v1.0.2 there is a support for lower time frame but this just puts a dot indicating the direction on the lower time frame rather than showing the full table of lower time frame slopes. I take it that it isn't support as of yet then?