madpipa wrote:Hi Steve,

I have been using the iHistory v1.8 indi for a while. I use it for showing both open & closed trades on 2 non-trading charts. It often left the wrong list of open trades, particularly after a group of trades had been closed (didn't seem to refresh correctly). So I made a slight mod to the code (about line 105) to read a new 1 minute candle & delete the existing list of trades. Then the usual process re-creates the list of trades.

I'm not much of a programmer - still learning - so I couldn't figure out why it wasn't working as intended. So I decided forcing the removal & rewriting of the list once a minute wasn't going to use much CPU & it was within my ability.

I also added some indication about whether it uses open/closed or both trades into the init function. Now it shows on the chart.

Cheers,
Mick