Hi all,
First of all, i want to say a lot of thanks for Steve, for putting us together in this forum. For Bob, Ellixe, Milanese, Baluda, and thousands of traders who have contributed to HGI. And for renexxxx, for the HGI Matrix.
As for myself, i was just a silent reader, since the day this forum born, well actually i've been silence in ForexFactory Nanningbob V5.
I'm a big fans of 10.6 EDSEL, and Tom DeMark TrendLine (TDMTL). I've been using those combination on D1 chart, for a few months, until I find HGI. Throughout the trial and error, I am now, quite satisfy with the performance of HGI. But, I'll be feel ashamed, if I don't share any thought, or suggestion, to this forum, after some trial I did. (I'm not a coder, so I do my trading system manually)
So, here I am, introducing you the combination, that now I've used for the last few weeks, which I found may optimize the performance for HGI pending order.
Basically, It still the same basic concept as the HGI (btw, I'm using HGI v17.00), the only difference is where I'll put my pending order. Therefore, if you haven't understand how HGI or TDMTL work, please visit, http://www.stevehopwoodforex.com/phpBB3 ... p?p=105044 first. I'll explain it, with imaginary cases (Steve's style):
1. Let's say, HGI show BUY Signal (Big Green Arrow, Blue Wavy, or Green RAD Arrow), inside the TDMTL. Then instead of putting a pending order in the next +20 line, I'll wait for the candle to close and breakthrough the TDMTL, and put the pending order, on the high point of the previous candle. And close the order, after 5 candles (well, I know it's debatable, but I found this quite true).
for example: 2. Let's say, HGI show BUY Signal (Big Green Arrow, Blue Wavy, or Green RAD Arrow), outside the TDMTL. Then put the pending order, on the high point of the previous candle.
for example: I think it's enough for you, to get the point, on how this system work. The same goes for the SELL Signal. But this system didn't go very well with range signal (Yellow Wavy / small arrow). But I suppose, it will give the signal inside the TDMTL, and will end just before it touch the TDMTL Line, where you'll close your order.
Well, that's all I can share for now. Please share any suggestions, for this system approach. And i'll appreciate for anyone who might want to code an EA for this system.
Best Regards,
Noer Fadzri Perdana Dinata
