HGI - Page 158

Post by **nanningbob** » Fri Feb 06, 2015 1:25 am

The wavy lines are set on candle close so they should only post one . The older versions didn't have this feature but the newer updates should post only on candle close. Have I missed something?

Post by **nanningbob** » Fri Feb 06, 2015 1:28 am

ronemshoff » Thu Feb 05, 2015 11:05 am wrote:Bob, when you have some time, in 16.04, explain settings igiCustom and ignoreFuture please.

Also i know you dont watch lower time frames, but i am testing 15 minute and getting multiple wavy symbols both yellow and blue on the same candle when price is inn a consolidation like Asia session. Is this normal, is this something that can be fixed so not so many wavy symbols on the same candle. one blue and one yellow would be preferred maximum. tnx ron

They are two separate signals so I suppose both could post at the same time or candle if they are at the decision point of the formula.

parkhead · Post by **parkhead** » Fri Feb 06, 2015 1:37 am

milanese » Fri Feb 06, 2015 9:11 am wrote:
milanese » Thu Feb 05, 2015 10:37 pm wrote:
pacers » Thu Feb 05, 2015 8:44 pm wrote:Also something else...

It is important when trading H4 to know the general trend on D1 so is it possible in next versions to add to the New Market Info the possibility to show trend on D1? Unless there is already something like this and i don't know about it...
try the attached one it shows you the actual D1 HGI signal

Cheers

Tommaso
I forgot to explain the signal shown in the attached img means no signal on the actual D1 candle

Cheers

Tommaso

I am only getting the yellow wavy showing up on this.

pacers · Post by **pacers** » Fri Feb 06, 2015 7:15 am

1) Tommaso i think the NewMarketInfo with D1 signal gives an alert when the signal changes on D1. Can you put an option to enable/disable the alert popping up? Because i want to know what is going on with the D1 when i am trading the H4 but i don't need alerts popping up when something changed in D1. It will make everything a bit confusing.

2) Also i think the image shows the problem that people think they have with signals on top of the other. If you see wavies that are one after the other overlap. If you zoom in it will clear but a recommended solution is maybe if you can make signals to avoid overlapping each other.

Screen Shot 2015-02-06 at 08.07.43.png

Anyways just a few ideas if you want them...

Post by **milanese** » Fri Feb 06, 2015 7:27 am

parkhead » Fri Feb 06, 2015 1:37 am wrote:
I am only getting the yellow wavy showing up on this.

make sure that you have the indicator you have in the HGIndicatorName defined installed..

Post by **milanese** » Fri Feb 06, 2015 7:42 am

pacers » Fri Feb 06, 2015 7:15 am wrote:1) Tommaso i think the NewMarketInfo with D1 signal gives an alert when the signal changes on D1. Can you put an option to enable/disable the alert popping up? Because i want to know what is going on with the D1 when i am trading the H4 but i don't need alerts popping up when something changed in D1. It will make everything a bit confusing.

2) Also i think the image shows the problem that people think they have with signals on top of the other. If you see wavies that are one after the other overlap. If you zoom in it will clear but a recommended solution is maybe if you can make signals to avoid overlapping each other.

Anyways just a few ideas if you want them...

1) no it gaves no alert, it is only a little helper, as I told you take a look to the HGI-Matrix it is a fantastic HGI dashboard, using MTF with aler sytem ecc...
2) just define a smaler wavy size for avoiding this...

Cheers

Tommaso

Post by **milanese** » Fri Feb 06, 2015 7:55 am

this is the NewMarket Info indicator showing the D1 signal with Yellow/DodgerBlue wavies like the HGI OOTB uses, first version I posted was an old one I code time ago for an user, when HGI showed OOTB too the wavy lines only yellow...

NewMarketInfoBa_D1.mq4

Cheers

Tommaso

pacers · Post by **pacers** » Fri Feb 06, 2015 8:04 am

milanese » Fri Feb 06, 2015 7:55 am wrote:this is the NewMarket Info indicator showing the D1 signal with Yellow/DodgerBlue wavies like the HGI OOTB uses, first version I posted was an old one I code time ago for an user, when HGI showed OOTB too the wavy lines only yellow...

Cheers

Tommaso

Thank you for all your help!

Post by **art** » Fri Feb 06, 2015 8:51 am

Hi tomasso, when you load the new D1 indie you just put up, on the chart with HGB all the info down the left hand side flashes on and off, cheers

Post by **milanese** » Fri Feb 06, 2015 9:00 am

art » Fri Feb 06, 2015 8:51 am wrote:Hi tomasso, when you load the new D1 indie you just put up, on the chart with HGB all the info down the left hand side flashes on and off, cheers

yes I know this problem, it is caused by an interferenze between the user display output HGB uses and the time-invervall the indicator checks the D1 HGI signal..

Cheers

Tommaso