Stochy Bob

Vlokkies · Post by **Vlokkies** » Fri Nov 21, 2014 10:48 am

Thanks for the clarification, appreciate it.

earlb38 · Post by **earlb38** » Fri Nov 21, 2014 1:22 pm

Hi
If i'm in the wrong thread to ask these questions just point me where to go pls.

I only updated Stocky Bob about 4 hrs ago so not sure if that may have affected results

The GBPAUD looks like it reached the stock 10 level but did not close the 2 trades also has not opened pending order either
I have default 90/10

same on 2 other pairs

Steve said not to mess with Stock if you dont know what your doing which is me

every thing is default for Stocky Bob

Post by **kwchau** » Fri Nov 21, 2014 2:04 pm

Hi Steve,

Please ignore my PM to you earlier today, I've found the problem with my coding. Since I'm not sure I've sent this second message through the PM system, I just repeat it here.

Cheers

earlb38 · Post by **earlb38** » Fri Nov 21, 2014 3:03 pm

Sorry forget pending order i assume on wrong side of 240 line

but did hit stoch10 line so i thought it should close the trade

checked other trade also hit stoch10 line but did not close either

Post by **SteveHopwood** » Fri Nov 21, 2014 5:40 pm

earlb38 » Fri Nov 21, 2014 3:03 pm wrote:Sorry forget pending order i assume on wrong side of 240 line

but did hit stoch10 line so i thought it should close the trade

checked other trade also hit stoch10 line but did not close either

Not in your picture, it hasn't.

earlb38 · Post by **earlb38** » Fri Nov 21, 2014 5:49 pm

perhaps this picture shows it better i closed this manual when back up over stoch10

Post by **SteveHopwood** » Fri Nov 21, 2014 6:00 pm

earlb38 » Fri Nov 21, 2014 5:49 pm wrote:perhaps this picture shows it better i closed this manual when back up over stoch10

This has made me have a look. I have a strange EJ buy that closed when Sto was only just over 10, so it should not have closed. I will have a look at the code.

Post by **SteveHopwood** » Fri Nov 21, 2014 6:09 pm

Cannot see anything wrong with the code - which is as simple as code gets. I had disabled snapshots and have re-enabled it. We will just have to see what happens next week.

earlb38 · Post by **earlb38** » Fri Nov 21, 2014 7:15 pm

Thanks
I have snapshots set to false but will wait and see next week maybe you will find other reason

jlcgarcia · Post by **jlcgarcia** » Sat Nov 22, 2014 5:32 pm

SteveHopwood » Wed Nov 19, 2014 7:50 pm wrote:

Please do post your multi-pair version once finished.

Hi friends,

I have opened another thread for the multi-pair version of this EA. Take a look here:

http://www.stevehopwoodforex.com/phpBB3 ... f=5&t=3947

Regards

José Luis