ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Place your new trading idea here to see if someone can automate it.
Post Reply
GT3RS
Trader
Posts: 198
Joined: Fri Dec 23, 2011 1:58 pm

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by GT3RS »

Wow! 18 winners from 18! That's amazing!

However, I suspect you are right in saying that you aren't trading it properly! Unless you're monitoring 50 pairs or something!

Why not post some charts so we can see what you've been doing?
User avatar
coolncalm
Trader
Posts: 173
Joined: Mon Dec 12, 2011 1:09 am

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by coolncalm »

crs247 wrote: At first I want to say "thank you" very much for the hard work you put into this. I am using your system on a small real account and honestly said, I think I'm not using it all correctly. But since Wednesday I had 18 trades with it. And believe it or not, ALL of them have been winners. :D

regards
Chris
Oh, I believe you, my dear friend. I trade it on 3 accounts in conservative (1% risk; edge of 3+), moderate and aggressive (5% risk; all valid trades) modes. The aggressive mode doubles every 2 weeks!!! :D (it only takes 10 successful trades at an edge of 2 to double an account at 5% risk/trade with each trade locked-in before another is taken).

EDIT: I didn't want to say it upfront because I was sure no one would believe I wasn't being reckless. I needed someone neutral to say it first. Welcome on board the CTS train, cr247. Imagine what we can accomplish when this system becomes automated!
Last edited by coolncalm on Sat Oct 13, 2012 7:46 pm, edited 1 time in total.
There's simplicity in every complexity.
fire580
Trader
Posts: 314
Joined: Wed May 09, 2012 4:51 pm

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by fire580 »

Thank you coolncalm and RJo for all your hard work that your are so graciously sharing this with us. At first I just couldn't figure it out.... but now after reading the instructions about fifty times I have a descent grasp, and my first two trades last night were successful. I do have a question regarding the

DMPBidDiffsMa's and how to use this - Are you saying that in a UT-RR there becomes a point where the DP is so far away from the MP that instead of the WP showing above the MP on the chart we should start to trade as if it was already showing below the MP thus an emerging DT? but how do you see that with this indicator?
thelearner
Trader
Posts: 114
Joined: Tue Sep 11, 2012 9:35 am

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by thelearner »

wow this thread is heavy on my brain.....I read your first post like three times and still have no clue LOL. I am gonna relax a bit and then read it again till I get it.... perhaps the amount of indi that confuses me? (blaming the indi now, really?? shame on me LOL). More picture guys....it always get me to understand quicker than lot of words (or just don;t mind me blabbering.....)
thelearner
Trader
Posts: 114
Joined: Tue Sep 11, 2012 9:35 am

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by thelearner »

Xeroforex wrote:
Ahhhh I was struggling with that, but thought that it was the DP movement.

Attached for anyone interested is a visual representation of some rules of CoolCalms very fine system, thanks to all who contribute, and it's great to see Alorente here, he is a very insightful trader

Cheers...Ted
WOW...this is what I need. Visual lines :) thank you very much..now my brain understands it better
thelearner
Trader
Posts: 114
Joined: Tue Sep 11, 2012 9:35 am

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by thelearner »

I don;t actually figure out the 28 combinations....so I made the bigger picture for 8 basic combinations to be used on the handbook. If you could write more on the combinations I would make a picture for each combination.
I only use basic photoshop skill so....forgive the ugliness :P
You do not have the required permissions to view the files attached to this post.
User avatar
fxozgirl
Trader
Posts: 1176
Joined: Wed Nov 16, 2011 9:16 am
Location: Melbourne, Australia

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by fxozgirl »

I've been reading and reading this thread all week and loving it, but haven't had time to set up charts. I will do that over the weekend and help with posting next week, so we can all learn together :D
thelearner
Trader
Posts: 114
Joined: Tue Sep 11, 2012 9:35 am

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by thelearner »

RJo wrote:That's great news, ozgirl.

I found 2 more entry combinations just now, so we're up to 30. I'm fairly confident this will be it.

Edit: Did I say 2... I meant 4. :lol: So, 32 total.
Woohooooo....I don't exactly understand at this point but....YAY! :lol:
Will wait patiently for your description of each combination.
Btw can I ask a little more detail on how A-team indi work...It shows if price moves outside FastTMAline at h1 (orange),h4 (magenta) and d1 (aqua) right? So it is non repainting and also work as the nearest S/R at that point. I apologise because I have 0 coding skill and these indi are taking my brain to different circuit :roll:

regards~
fire580
Trader
Posts: 314
Joined: Wed May 09, 2012 4:51 pm

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by fire580 »

Thank you RJo great explanation.... and I'm glad I had it right - all starting to come together - a great method.
fire580
Trader
Posts: 314
Joined: Wed May 09, 2012 4:51 pm

Re: ADAPTING NB10.2A FOR LOWER TF & RM TRADING - 10.2A CTS

Post by fire580 »

Can someone help I can't seem to open the Pivot Composition Doc - ( I'm an older guy who didn't grow up with computers) - it took me a while to make this attachment :oops:
You do not have the required permissions to view the files attached to this post.
Post Reply

Return to “Ideas for Possible Automation”