Fx Pooler ver 6b Single

Post Reply
User avatar
Pooler
Trader
Posts: 175
Joined: Sat Dec 31, 2011 5:15 pm
Location: Port Elizabeth, South Africa. A friendly windy spot at the bottom of Africa

Re: Fx Pooler ver 6b Single

Post by Pooler »

peterke wrote:Pooler, a general question, now that the strategy has changed from a tight daily open retracement are you thinking to run this ea on a small number of pairs at a higher level of risk or most pairs at a low level of risk. Reason for the question is that some pairs suit this strategy eg USDCAD while others I'm struggling to get to trade for any period of time? I suspect it will depend on how the MS part of the strategy works?

rgds\\Peter
Hi Peter,

Which EA you referring to?
Last edited by Pooler on Wed May 08, 2013 3:00 pm, edited 1 time in total.
A Luta Continua
peterke
Trader
Posts: 56
Joined: Wed Nov 16, 2011 9:17 am

Re: Fx Pooler ver 6b Single

Post by peterke »

The ADR version reversal only.

rgds
Peter
User avatar
Pooler
Trader
Posts: 175
Joined: Sat Dec 31, 2011 5:15 pm
Location: Port Elizabeth, South Africa. A friendly windy spot at the bottom of Africa

Re: Fx Pooler ver 6b Single

Post by Pooler »

I'll pm you
A Luta Continua
patman
Trader
Posts: 68
Joined: Sat Dec 10, 2011 1:48 am

Re: Fx Pooler ver 6b Single

Post by patman »

I put 6c2 on USDJPY (also on GBPJPY, USDCHF, EURGBP & XAUUSD - no orders on these)
On USDJPY
It opened a sell 1.00 lots @ 16:53
Then at 16:54 it opened 10 more orders sell 0.05

Is this correct?


At 17:29 I got an email from Alpari UK
"We are getting a lot of orders from your account, if you are using an EA, please disable it or check the settings on it as it is disrupting our servers"

Currently getting "Trade Is Disabled" if I try to place a manual order
Would the 10 simultaneous orders cause them to email me or is it something else?
User avatar
Pooler
Trader
Posts: 175
Joined: Sat Dec 31, 2011 5:15 pm
Location: Port Elizabeth, South Africa. A friendly windy spot at the bottom of Africa

Re: Fx Pooler ver 6b Single

Post by Pooler »

Did you use a template?
A Luta Continua
User avatar
Pooler
Trader
Posts: 175
Joined: Sat Dec 31, 2011 5:15 pm
Location: Port Elizabeth, South Africa. A friendly windy spot at the bottom of Africa

Re: Fx Pooler ver 6b Single

Post by Pooler »

peterke wrote:The ADR version reversal only.

rgds
Peter
Hi,

I don't use the MS on this EA. As I explained with the settings--the first level is set at 50 000 pips for level 1. I use the settings for 34 pairs
A Luta Continua
patman
Trader
Posts: 68
Joined: Sat Dec 10, 2011 1:48 am

Re: Fx Pooler ver 6b Single

Post by patman »

Pooler wrote:Did you use a template?

Hi Pooler,

Initially I did use a template to set how the chart looked but dropped the EA onto each chart.
and loaded the set file for 62c.
Then I enabled Expert Advisors.

I'll clear everything and start again - we'll see what happens.

I have to get Trade is disabled removed first

Thanks
User avatar
Pooler
Trader
Posts: 175
Joined: Sat Dec 31, 2011 5:15 pm
Location: Port Elizabeth, South Africa. A friendly windy spot at the bottom of Africa

Re: Fx Pooler ver 6b Single

Post by Pooler »

patman wrote:
Pooler wrote:Did you use a template?

Hi Pooler,

Initially I did use a template to set how the chart looked but dropped the EA onto each chart.
and loaded the set file for 62c.
Then I enabled Expert Advisors.

I'll clear everything and start again - we'll see what happens.

I have to get Trade is disabled removed first

Thanks
You must drop the EA onto the chart after everything is ready. And load the EA for each chart
A Luta Continua
patman
Trader
Posts: 68
Joined: Sat Dec 10, 2011 1:48 am

Re: Fx Pooler ver 6b Single

Post by patman »

Pooler,

Thanks for your time on this.
Turns out my fault.
The account has a 2 lot limit so orders were getting refused at the server.
6c2 was trying to place lots and lots of orders (I switched on manual confirmation)
As I hit the red X to not place each order 6c2 tried the next order.
So orders for 1lot then 2 lots then 3lots up to 10lots were attempted
then 10 orders for 0.05.
I think it must have been repeating the attempts and getting refused at the server.
Hence the email

I changed onto a different account so it should be OK now

Pat
username
Posts: 5
Joined: Tue Jul 10, 2012 7:50 am

Re: Fx Pooler ver 6b Single

Post by username »

Hi, yes 6c2 and 6c4 are like spam bots. They will try to open an order about 10 times per tick until it gets through. This seems to be the only way to force criminals to actually open an order. This is the same reason why some people got enormous log files. It will try to open a position, and log that try, for about 10 times for every incoming tick. Have that running on 28 pairs for a couple of hours....
Post Reply

Return to “Automated trading systems”