10.6 EDSEL

[nanningbob]

Because of the Ukraine USSR thing I am not willing to go out and make any predictions but CSS shows usd and gbp weakening, nzd stumbling and everything else flat with possible jpy strengthening some more. If you want to trade look for usd and gbp weakness trades as your best bet. NZD is out of character, eur and chf too tied up with Ukraine news, cad maybe a sleeper strengthen and JPY probably unless BOJ intervenes. So school starts and I am not committing a whole lot to the start of this week.

CSS crystal ball time. I really wasnt wanting to get into predictions with the Ukraine thing but USD weakness was only good for one day and then later it strengthened off of a news story. So ............

gbp weakness was a good call though and most pairs had 1 or 2 small runs with the gbp/usd and gbp/nzd having the biggest drops.

nzd stumbling was 1/2 accurate. It went up against the eur, gbp, and chf and ranged against the rest.

jpy was flat all weak with some range trading pulling some pips but not so hot until the usd/jpy had a good move.

Cad sleeper call was a bummer until Friday and then got some pips but would have done better playing weakness.

I said nothing about the aud. So had a winning week but not a great one. Covered my losses from last week and increased my account a couple of percentage points so back on track. Need a big week this last week to get to 10% increase but if not 5%+ will be acceptable for now. Will work on getting the ranging part of 10.6 working better so I can get back to my 10% a month again.

[nanningbob]

I made a pic of the daily CSS chart just before the close so i wouldnt have to wait until Monday to give out my weekly CSS reads. Had to use the windows paint program and decided to have some fun with the brush. SO without further ado here we go.

I think the Ukraine thing is now weighing down the euro currencies so eur, chf, and gbp are angling down. Unless a major story kicks up gbp will be on the bottom so look for gbp sells on all currencies. Take the eur and chf sells as they cross or angle at each other. eur/aud, eur/nzd and gbp/nzd gbp/aud look like good places to trade. If CAD, USD, or JPY angle up they would be good places to trade later in the week when they cross the euro pairs.

CAD seems to be weakening against everyone but the gbp so look for sells against it. aud/cad, nzd/cad, jpy/cad and usd/cad look for buys.

JPY has strengthened at the end of almost every month so I see no reason for that not to continue. JPY against all pairs except aud and nzd probably would work. usd/jpy would be another exception if they both go strong.

USD sitting on the weak side playing in the mud. maybe go up, maybe go down, maybe do nothing, Idont know right now. WIll sit it out for now until it makes up its mind. I think it wants to go up but those constant slightly bad news reports have kept it down.

Anyway, I took a break from my work, now I need to get back to my paperwork. Have a great weekend. :hi:

[xrismak]

Alorente,
Thanks for sharing that TSI Indi and Template, you are Indeed very right about the Traders Dynamic Index Indicator and it's been doing my Brain in bit by bit most times I might Exit a Profitable trade just because the Indicator screams something different at me but thanks to your Good Self I really won't need it Again, My 9 year old Daughter was the First to Spot it's Flaws and she Complained Bitterly about it giving too many Conflicting Signals, she likes to watch me trade sometimes especially when she's back from school, it Kind of Fascinates her and she's a Quick Learner but I just thought oh little Kid what does she know about Trading so long as it Gives me Coins to get her Loads of Pizza and Ice Cream. These Kids are growing up Sharper and Smarter these days hehehehehehehehe, so I think I will listen to her more Attentively Now, looks like she has become a bit of an Expert since she really has fewer things on her mind (No Worries About Paying Bills) except doing school homework, watching a bit of TV and Watching Daddy trade.


Many Thanks for Sharing, I will take it for a SPIN this Week on the Charts and let you know how I get on with it but I am Sure it will do what it is Expected to Do.

Have a Great Weekend Everyone.

xrismak

[alorente]

Alorente,
Thanks for sharing that TSI Indi and Template, you are Indeed very right about the Traders Dynamic Index Indicator and it's been doing my Brain in bit by bit most times I might Exit a Profitable trade just because the Indicator screams something different at me but thanks to your Good Self I really won't need it Again, My 9 year old Daughter was the First to Spot it's Flaws and she Complained Bitterly about it giving too many Conflicting Signals, she likes to watch me trade sometimes especially when she's back from school, it Kind of Fascinates her and she's a Quick Learner but I just thought oh little Kid what does she know about Trading so long as it Gives me Coins to get her Loads of Pizza and Ice Cream. These Kids are growing up Sharper and Smarter these days hehehehehehehehe, so I think I will listen to her more Attentively Now, looks like she has become a bit of an Expert since she really has fewer things on her mind (No Worries About Paying Bills) except doing school homework, watching a bit of TV and Watching Daddy trade.


Many Thanks for Sharing, I will take it for a SPIN this Week on the Charts and let you know how I get on with it but I am Sure it will do what it is Expected to Do.

Have a Great Weekend Everyone.

xrismak

High Xris,

I got your PM and answered it.

You will do well if you practice with TSI. I use it to confirm 10.6 and TMA. By the way, it works in all time frames. I love to scalp with TSI in M1 TF while I wait for trades from 10.6 on my 20 chart setup. I actually make more coins scalping M1 than with the others, but it takes full concentration and its best done in short spurts, maybe 30 minutes at a time and then rest. If M1 is too hectic for you, try M5. Much more relaxed...

Here is a pic of some of Fridays M1 trades with GbpJpy. All of them were profitable. Exit is on return of price the the 60 MA (Green MA) or the 240 MA (White MA). You have to be quick with this. Some trades are only open for 3 or 4 minutes and most of them are for only 5 to 12 pips.

[alorente]

Here is my first rough thoughts of using TMA (numbers adjusted for quicker reaction using TMA true so lines dont change once candle is closed) instead of DP line. STO7 is changed to 90/10 for warnings. TMA top broken STO 7 signal. 10.6 readings with 4H CSS. gbp/nzd run.

1. First 10.6 read price touches the GREEN 60 MA showing range period entered. Trading both directions viable but only going to show trend trades. So we are looking at sells.
2. STO 7 now is in play. Warning given when price crosses the 90 line. YELLOW
3. Confirmation that price has breeched the top TMA line.
3a. pending sell trade is then set at xxx.000 or xxx.050 line.
3b. TP goal is the bottom line or use CSS or xxx.000 or xxx.050
4. CSS read tan nzd is higher than blue GBP so it is stronger showing sell only.
5. Trade series ends with CSS nzd and gbp touch or cross OR price touches green MA showing range area entered again.

Start new trades with STO 7 signal and breech of TMA or ride CSS signals until nzd and gbp cross, near, or touch. 6 total trades in a 4 week period. All go hundreds of pips but that is gbp/nzd very volatile.

This is strictly an idea at this point. DP is removed and replaced with TMA

4 reads to enter a trade.
1. 10.6 range or trending read.
2. TMA read
3. STO 7 read
4. CSS read

ALL agree go. This does not work on 1H.

Looks really interesting, Bob. The only drawback I see is that you have to work on only one pair and you may not get as many trades as I´m getting now with my 20 charts on the screen. Here is the setup I have on one of my three monitors...

You also dont have the TMA settings I am using at this time. The TMA settings you have would produce the same results with gbp/nzd. I will try to get to this but first I must get ready for the parents meeting Wednesday night. I have to have all the paperwork for next years enrollment done and approved by the new owners before I get back to this. So this is going to take a while. Send me a PM and I can send you the source code of the new TMA settings and you can play with it while I do bookwork.

Bob, can you please post the TMA true and CSS single pair indis that you show in your chart? I am sure I can find them in previous posts, but I would appreciate it if you post them again for me. Or you can PM them for me if you prefer... I want to test this new system while I trade 10.6 this week. I like it ...

Thanks, friend.

[davek]

Hi:
My platform got updated to build 610 and now my AEJ10.6 STO ALERT v1.2 w-60-240.mq4 does not load on my platform. I tried to recompile it but it has 1 error and 2 warnings, the error is 'i' - undeclared identifier, line 84, column 25, and the two warnings are: not all control paths return a value, one is on line 65 column 1, and the other is on line 186, column 1, I have no idea what that means. Could someone help me with this issue.

These are exciting times in this forum with Boldtrader and Al contributing their expertise, really looking forward to seeing what Bob is cooking up in his next transformation of 10.6 Edsel.

kind regards,
davek

[ace81]

Bob, can you please post the TMA true and CSS single pair indis that you show in your chart? I am sure I can find them in previous posts, but I would appreciate it if you post them again for me. Or you can PM them for me if you prefer... I want to test this new system while I trade 10.6 this week. I like it ...

Thanks, friend.

Hi Al

Below are TMA and Two pair css

[milanese]

Hi:
My platform got updated to build 610 and now my AEJ10.6 STO ALERT v1.2 w-60-240.mq4 does not load on my platform. I tried to recompile it but it has 1 error and 2 warnings, the error is 'i' - undeclared identifier, line 84, column 25, and the two warnings are: not all control paths return a value, one is on line 65 column 1, and the other is on line 186, column 1, I have no idea what that means. Could someone help me with this issue.

These are exciting times in this forum with Boldtrader and Al contributing their expertise, really looking forward to seeing what Bob is cooking up in his next transformation of 10.6 Edsel.

kind regards,
davek

Take a look here I posted some time ago versions working with all 6xx builds here
http://www.stevehopwoodforex.com/phpBB3 ... 283#p86283
http://www.stevehopwoodforex.com/phpBB3 ... 295#p86295


Cheers

Tommaso

[ace81]

Hi:
My platform got updated to build 610 and now my AEJ10.6 STO ALERT v1.2 w-60-240.mq4 does not load on my platform. I tried to recompile it but it has 1 error and 2 warnings, the error is 'i' - undeclared identifier, line 84, column 25, and the two warnings are: not all control paths return a value, one is on line 65 column 1, and the other is on line 186, column 1, I have no idea what that means. Could someone help me with this issue.

These are exciting times in this forum with Boldtrader and Al contributing their expertise, really looking forward to seeing what Bob is cooking up in his next transformation of 10.6 Edsel.

kind regards,
davek

Take a look here I posted some time ago versions working with all 6xx builds here
http://www.stevehopwoodforex.com/phpBB3 ... 283#p86283
http://www.stevehopwoodforex.com/phpBB3 ... 295#p86295


Cheers

Tommaso

Thanks Tommaso

[nanningbob]

I need to know what some of this stuff means and what it is suppose to do. TMA FAST ALs and TMA TRUE register the same lines on the screen when entered however they have different functions in the code. I feel I understand the other functions so I didnt ask questions about them.

Fast ALs my questions will be in red.

extern string TimeFrame = "Current";
extern int TMAPeriod = 50;
extern int Price = PRICE_CLOSE;
extern double ATRMultiplier = 2.0;
extern int ATRPeriod = 100;
extern double TrendThreshold = 0.4; I dont understand what trend threshold means. What does it do if I change it to 1.0 or 0.1. What is its function??
extern bool ShowCenterLine = false;


extern bool alertsOn = false;
extern bool alertsMessage = false;
extern bool alertsSound = false;
extern bool alertsEmail = false;
extern bool MoveEndpointEveryTick = false;What is the difference between every tick and the other option when it is false. Is it every candle, minute??????????
extern int MaxBarsBack = 5000;

NOW TMA TRUE functions:

extern bool Interpolate = true; What does this do and changing it to false would do what??
extern bool alertsOn = true;
extern bool alertsOnCurrent = true; What does this do and changing it to false would do what??
extern bool alertsOnHighLow = true;What does this do and changing it to false would do what?? I assume this is a break of the high low bands??
extern bool alertsMessage = true;
extern bool alertsSound = false;
extern bool alertsEmail = false;