Hi Naruto,Bruster400 » Thu Aug 23, 2018 3:10 pm wrote:smilee89 » Thu Aug 23, 2018 1:22 pm wrote:Houston, we have a problem.
I uploaded earlier today a screenshot of USDCHF shwoing blue MA crossing red MA UP, more than 1 closed bar back.
http://www.stevehopwoodforex.com/phpBB3 ... 88#p163323
Now it appears to change.
Ok, so here's what I think is happening... The red line that you've highlighted is a plot of the D1 Sto7 value at each 1hr bar. So on hour 1 of the day the indi looks to see what the D1 Sto value is and it plots it, then hour 2 it checks again and plots the new value, then hour 3 etc etc. In your first image, your chart had been open for the whole of the day and so it had managed to capture new D1 Sto7 values for each hour. When you re-loaded the template the red line can only see what the D1 Sto7 value is right now. There is no record of what the D1 value was an hour ago because the D1 candle isn't closed. That is why all previous days are flat lines - they are just the single closed value for the day.
It's that old "wet paint" rather than re-painting problem. You have to realise that when you're using HTF data - everything between HTF closes can change.
Hope that helps clear that up.
I refer to this post from Bruster and it should be a similar situation with MTF RSI. If you switch the timeframes it refreshes.About MTF_RSI, I notice it may repaint. Is that correct?
Cheers
Leon